live electronic circuts

Circuit operation

Tuesday, December 10, 20130 comments

Device purpose:

This circuit operates two LED strips in pulsing mode, i.e. one LED strip goes from off state, lights up gradually, then dims gradually, etc. while the other LED strip does the contrary.
Each strip can be made up from 2 to 5 LEDs at 9V supply.

:

The two Op-Amps contained into IC1 form a triangular wave generator. The rising and falling voltage obtained at pin #7 of IC1 drives two complementary circuits formed by a 10mA constant current source (Q1, Q2 and Q5, Q6) and driver transistor (Q3 and Q6).
R4, R5 & C1 are the timing components: the total period can be varied changing their values. R7 & R8 vary the LEDs brightness.

Notes:

  • For those whishing to avoid the use of trimmers, suggested values for 9V supply are: R4=3M9, R9 & R13=47K and trimmers replaced by a short.
  • Whishing to use a wall-plug adapter instead of a 9V battery, you can supply the circuit at 12V, allowing the use of up to 6 LEDs per strip, or at 15V, allowing the use of up to 7 LEDs per strip.
  • In this case, the value of the trimmers R7 & R8 should be changed to 100K.

Share this article :

Post a Comment

 
Support : Cara Gampang | Creating Website | Johny Template | Mas Templatea | Pusat Promosi
Copyright © 2011. electronics news and updations - All Rights Reserved
Template Created by Creating Website Modify by CaraGampang.Com
Proudly powered by Blogger